BLACKLIGHT : black effect Protection film

Name: BLACKLIGHT — BLACKLIGHT : black effect Protection film · HEXIS
Brand: HEXIS

Paint Protection Films

Our solutions for headlights and rear lights

gloss 760 mm 15 m long term Automotive protection film

The BLACKLIGHT is an anti-impact film protection to keep car headlights spotless.

BLACKLIGHT is an adhesive film specially developed for protecting transparent vehicle surfaces. Due to its excellent shock-absorbing properties, this film protects glazings, head and back lights, etc. against chips caused by stones, insects, washing brushes, etc. Glossy, light grey, transparent surface finish.

These ultra-clear products produce a crystal-tinted effect that allows the maximum amount of light emitted by the headlights to pass through.

Presentatie

So you want to keep your headlights looking impeccable, with that racing car look? HEXIS have developed a range of high quality films for the customisation and long-term protection of your car lights.

Samenstelling & formaat

Filmtype	Automotive protection film
Liner	Liner PET
Breedte (mm)	760,1520
Lengte (m)	15

Verwerking

Aanbrengmethode	Wet application method
Minimale aanbrengtemperatuur	+10 °C (+50 °F)
Gebruiksbereik	-40 °C to +90 °C (-40 °F to +194 °F)
Duurzaamheid	long term

Technische eigenschappen

Tack	7 N /25 mm
Hechting (20 min)	11 N/25 mm
Hechting (24 h)	12 N/25 mm
Afpelkracht liner	0.1 N/25 mm
Treksterkte	> 25 N/25 mm
Krimp (168 h / 70 °C)	< 0.2 mm

Het product

Tinted light grey
Anti-shock and self-healing
Ultra-clear PU film, 130 µm
Glossy smoke finish +++
Durability: up to 7 years (vertical exposure)
Available in 760, 1520 mm x 5 and 15 m (other retail options are possible, depending on stock availability)

Toepassing & onderhoud

Withstands the heat of a bulb up to 140 °C (284 °F) for a duration of 3 hours.

Cut the film to the size of the part to be wrapped, allowing +10 cm (4 in.) of extra margin.

The remaining film must be stored on its original core (do not cut the rolls into several lengths or widths, do not repackage the product); the roll must be closed immediately and properly (masking tape or roll-collars) after use in order to preserve all its qualities.

Apply to a surface that is clean and free from any traces of contaminants (dust, grease, wax, silicone, etc.).

Particular care must be taken to clean the angles and periphery of the glass surfaces in order to enable the film to adhere properly to the surface.

Only apply to an undamaged substrate.

If the substrate is damaged, the application and the removal are at the judgement and risk of the installer.

Caution: The Blacklight film is intended to be applied to exhibition vehicles or vehicles used on off-road terrains not suitable for public traffic (e.g. private lanes, circuits, etc.).
It is recommended to enquire about the current legislation in the country of use prior to any appearance modification of the vehicle's lighting, warning and glazing devices for applications other than those stated above. HEXIS cannot be held liable for any non-compliance with the current legislation of the country of use.

Aanbevelingen

To facilitate application, HEXIS have several types of squeegees in their range of accessories, ranging from softer to harder (plastic or felt).
For more information on the application method of the BLACKLIGHT film, please refer to its Application Guide available under the "Professionals" heading, in the "Solar and safety films” category on our website www.hexis-graphics.com.

Duurzaamheid in detail

Vertical exposure:
up to 7 years (under normal road use conditions).

Lifespan depends on the type of substrate, substrate preparation, exposure conditions and nature and frequency of the cleaning.

For instance, it is estimated that a south-facing exposure (in the northern hemisphere) will divide the durability by two. The same applies to a horizontal exposure. In addition, elevated temperatures (above 50 °C) (+122 °F) or pollution significantly reduce this durability.