White/Black
This film is composed of 160-μm, micro-perforated, colaminated (black/white), monomeric PVC, which is coated with a pressure-sensitive acrylic adhesive. Usable for solvent, eco-solvent, latex and UV inkjet printing.
The product components allow for the printing of graphics on one side (white side) while maintaining the possibility to see through the opposite side (black side).
This film is intended for flat surfaces such as windows.
Samenstelling & formaat
| Filmtype | Monomeric PVC |
| Dikte | 160 µm |
| Kleeflaag | clear |
| Liner | Liner PE |
| Breedte (mm) | 1370,1520 |
| Lengte (m) | 50 |
Verwerking
| Toepassing | window graphics |
| Ondergronden | vehicles |
| Oppervlakken | slightly curved |
| Aanbrengmethode | Dry application method |
| Minimale aanbrengtemperatuur | +10 °C (+50 °F) |
| Gebruiksbereik | -10 °C to +50 °C (+14 °F to +122 °F) |
| Duurzaamheid | short term |
Technische eigenschappen
| Hechting (24 h) | 8 N/25 mm |
Toepassing & onderhoud
- Before installation, check that the film is completely dry to avoid excessive elongations.
- Apply to untreated, clean and dry mineral glass. Not to be immersed in water.
- Prior to application, clean the substrate with solvent and ammonia-free detergents only.
- LLeave a 5-mm space between the window seals and the edge of the MICRO6 film. Never apply the film directly to the window seals.
- It is possible to peel the film off the substrate. Remove residual adhesive if necessary.
Caution: This micro-perforated film cannot be used on emergency exits of public transport vehicles (Annex 5 of the Geneva Regulation R43 or the 92/22/CEE directive). The customer is strongly advised to contact the competent local authorities who will validate the conformity of the vehicle with the road traffic regulations in effect.
Aanbevelingen
- On flat substrates, it is recommended to laminate with an adhesive-coated, super-transparent, cold laminating film (PG836), applied using a laminator.
DO NOT USE heat-sealing (heat encapsulating) film.
- The adhesion of edges and corners of the MICRO6 film can be reinforced with our self-adhesive edge sealing tapes "FPG836" or our sealing varnish VR7077 in case of extreme mechanical stress.
The sealing must be done by superposing the tape or applying varnish on the MICRO6 film and the glass substrate while avoiding any contact with the seals.
- For more information on the application method of the MICRO6 film, please refer to its Application Guide on the "Professionals" pages, category "Digital printing media" on our website www.hexis-graphics.com.
Duurzaamheid in detail
- Vertical outdoor exposure: 2 years.
- Removability: Up to 1 year without leaving significant residues (upon substrate).
