White/Black
Film composed of 160-µm, micro-perforated, colaminated (black/white), polymeric PVC, which is coated with a pressure-sensitive acrylic adhesive. Usable for solvent, eco-solvent, latex and UV inkjet printing.
Samenstelling & formaat
| Filmtype | polymeric PVC |
| Dikte | 160 µm |
| Kleeflaag | clear |
| Liner | Liner PE |
| Breedte (mm) | 1050,1370,1520 |
| Lengte (m) | 30 |
Verwerking
| Toepassing | window graphics |
| Ondergronden | windows |
| Oppervlakken | slightly curved |
| Aanbrengmethode | Dry application method |
| Minimale aanbrengtemperatuur | +10 °C (+50 °F) |
| Gebruiksbereik | -20 °C to +65 °C (-4 °F to +149 °F) |
| Duurzaamheid | short term |
Technische eigenschappen
| Hechting (24 h) | 8 N/25 mm |
| Brandgedrag | EN 13501-1 |
Toepassing & onderhoud
- Apply to untreated, clean, dry and non-submerged mineral glass.
- Before application, clean the substrate with solvent-free and ammonia-free detergents only.
- Leave a 5-mm space between the window sealings and the edge of the MICRO1 film. Never apply the film directly to the window sealings.
- It is possible to peel off the film from the substrate. Remove residual adhesive if necessary.
Caution: This micro-perforated film cannot be used on emergency exits of public passenger transport vehicles (Annex 5 of the Geneva Regulation R43 or the 92/22/CEE directive). The client is strongly advised to contact the competent local authorities that will establish the conformity of the vehicle with the road traffic regulations in effect.
Aanbevelingen
- On flat substrates, it is recommended to laminate with an adhesive-coated, extra-clear, cold laminating film (PG836), applied using a laminator.
DO NOT USE heat-sealing (heat encapsulating) film.
- For vehicle rear windows (slightly curved), we recommend using our "cast" cold laminate PC50MICP.
- The MICRO1 film's adhesion at edges and corners can be reinforced with our self-adhesive edge sealing tapes "FPG836" for flat surfaces, "FPC50MICP2" for slighty curved substrates or our VR7077 sealing varnish in case of extreme mechanical stress.
The sealing must be done by superposing the tape or varnish between the MICRO1 film and the glass substrate while avoiding any contact with the seals.
- For more information on the application method of the MICRO1 film, please refer to its Application Guide available under the "Professionals" heading, in the "Digital printing media” category on our website www.hexis-graphics.com.
Duurzaamheid in detail
- Vertical outdoor exposure: 2 years.
- Removability: Up to 1 year without leaving significant adhesive residues (upon substrate).
