White gloss/Black
This film is composed of 160-µm, micro-perforated, colaminated (black/white), polymeric PVC, which is coated with a pressure-sensitive acrylic adhesive. Usable for solvent, eco-solvent, latex and UV inkjet printing.
The product components allow for the printing of graphics on one side (white side) while maintaining the possibility to see through the opposite side (black side).
Samenstelling & formaat
| Filmtype | polymeric PVC |
| Dikte | 160 µm |
| Kleeflaag | clear |
| Liner | Liner PE |
| Breedte (mm) | 1520 |
| Lengte (m) | 50 |
Verwerking
| Toepassing | window graphics |
| Ondergronden | windows |
| Oppervlakken | slightly curved |
| Aanbrengmethode | Dry application method |
| Minimale aanbrengtemperatuur | +10 °C (+50 °F) |
| Gebruiksbereik | -20 °C to +65 °C (-4 °F to +149 °F) |
| Duurzaamheid | short term |
Technische eigenschappen
| Hechting (24 h) | 5 N/25 mm |
| Rek bij breuk | min. 50 % |
Toepassing & onderhoud
- Apply to untreated, clean and dry mineral glass. Not to be immersed in water.
- Prior to application, clean the substrate with solvent and ammonia-free detergents only.
- Leave a 5-mm space between the seals and the edge of the MICRO50 film. Never apply the film directly to the window seals.
- It is possible to peel the film off the substrate. Remove residual adhesive if necessary.
Caution: This micro-perforated film cannot be used on emergency exits of public transport vehicles (Annex 5 of the Geneva Regulation R43 or the 92/22/CEE directive). The customer is strongly advised to contact the competent local authorities who will validate the conformity of the vehicle with the road traffic regulations in effect.
Aanbevelingen
- On flat substrates, it is recommended to laminate with an adhesive-coated, super-transparent, cold laminating film (PG836), applied using a laminator.
DO NOT USE heat-sealing (heat encapsulating) film.
- For vehicle rear windows (slightly curved), we recommend using our "cast" cold laminate PC50MICP2.
- The adhesion of edges and corners of the MICRO50 film can be reinforced with our self-adhesive edge sealing tape "FPG836" or our sealing varnish VR7077 in case of extreme mechanical stress.
The sealing must be done by applying the tape or varnish on the MICRO50 film and the glass substrate while avoiding any contact with the seals.
- For more information on the application method of the MICRO50 film, please refer to its Application Guide on the "Professionals" pages, category "Digital printing media" on our website www.hexis-graphics.com.
Duurzaamheid in detail
- Vertical outdoor exposure: 2 years.
- Removability: up to 1 year without leaving significant adhesive residues (upon substrate).
