Ultra clear

• Prior to any film application to a substrate prone to degassing, it is the responsibility of the prescriber and applicator to verify the compatibility between the film and the substrate and to carry out an optimal substrate degassing (in the case of synthetic glass such as PMMA). The applicator is liable for any appearance of bubbles due to substrate degassing.
• Indoor application.
• Application to vertical glass surfaces, up to a maximum of 2.5 m².

Covering part or all of the window by a fully or partially printed film can cause localised heating of the glass (higher than +25 °C (+77 °F) depending upon colour and opacity of the graphics) relative to the non-covered surface. It is the responsibility of the customer/user/installer to make sure of the compatibility of the processed or unprocessed film with the glass/environment before applying the latter.

• During storage, always handle with clean and dry hands.
• Always remove the liner right before application, and squeegee the film right after as instructed during the HEXIS training courses.
• Application with soapy water only.
• Adhesion to glass, except grain substrates.
• Only use special tools dedicated to the application of solar / safety films.
• The film should not be covered with stickers or self-adhesive films.
• If peeled off after its application, the deterioration of the structure and appearance of the film will be irreversible.
• After application you must wait for one month before cleaning the film's surface with soapy water for the first time.

• Vertical indoor exposure on flat window panes:
  Unprinted: 2 years without significant traces of adhesive.